Page 1 of 1

66 xlch rear fender

PostPosted: Sat Feb 08, 2020 7:08 pm
by Otis
Where does the Taillight wires enter the rear fender. I was told that they go under the fender and not through a hole like a 68 or 69 model. I would like to verify that before paint.

Re: 66 xlch rear fender

PostPosted: Sat Feb 08, 2020 11:34 pm
by Magneto Sportster
That is correct, 1966 was the last year that the tail light wire ran along the inside of the fender all the way to the bottom and exited at the bottom near the rear brake switch.

Hopefully you are able to see what I am referring to in this photo of my all-original 1966 XLCH:

Image[url=https://flic.kr/p/2iqVcXP]

Re: 66 xlch rear fender

PostPosted: Sun Feb 09, 2020 7:38 am
by Otis
Is the bottom of the fender terminated the same as the later fender or is it a little shorter?

Re: 66 xlch rear fender

PostPosted: Sun Feb 09, 2020 5:31 pm
by Model H
Otis wrote:Is the bottom of the fender terminated the same as the later fender or is it a little shorter?


If you are referring to the rear part of the fender (below the taillight), yes it is the longer of the two.

65 was the last year for the "short" rear fender.

66 CH was a one year only rear fender, no taillight wire hole, wire guide goes to the bottom of the front of the fender.

Coil indent appeared in 67 on the H, I think 69 for the CH.

Re: 66 xlch rear fender

PostPosted: Sun Feb 09, 2020 10:03 pm
by Otis
One last question
Is the part of the fender going towards the swingarm (lower front) the same length as the later fender?