Rear brake switch parkerizing

Production K Models

Rear brake switch parkerizing

Postby strong56KH » Fri May 08, 2020 6:23 pm

Has anyone tried parkerizing the rear brake switch, 72004-52, ala Bruce Palmer (without removing the fiber insulator and guts)? I think the fiber insulator for the big twin switch, 72004-39, was the same. In his book, he indicates that he has never damaged one using this method.

s-l1600.jpg
s-l1600.jpg (263.13 KiB) Viewed 4589 times
strong56KH
 
Posts: 164
Joined: Sat Oct 18, 2014 6:00 pm
Location: Virginia

Re: Rear brake switch parkerizing

Postby wz507 » Sat May 09, 2020 12:48 am

To answer your question I have not done what you asked about, but there’s not much to damage inside the switch so I wouldn’t be concerned with that, assuming it is all in good condition to start with. Since Parkerizing can be done at a relatively low tempt (150-170F), the phenolic face plate should have no issue tolerating those conditions for 10-20 minutes. You would want to submerse the switch in WD-40 immediately after draining Parkerizing solution from it to assure it any water present was displaced from the internals. Likely wouldn’t be a bad idea to soak it in an oil of your choice thereafter and allow to drain for an extended period of time to assure the inside was both free of moisture and well lubricated. The stem that activates the switch is cad plated and this might be etched a bit by the acidic Parkerizing solution.

I’ve disassembled these switches and restored the factory finish to the parts and was fortunate enough to not crack the ears when reassembling. If I was doing it again, I would likely do as Palmer suggests.

LR Brake light switch guts.jpg
LR Brake light switch guts.jpg (110.94 KiB) Viewed 4541 times
User avatar
wz507
 
Posts: 356
Joined: Fri Dec 11, 2015 9:13 pm


Return to K, KK, KH, KHK

Who is online

Users browsing this forum: No registered users and 22 guests