Page 1 of 2
counter shaft gear spacer
Posted:
Tue Nov 30, 2021 5:49 pm
by blewandoski
just started working on 52 K. Missing a few parts. Right now looking for the counter shaft gear spacer (35809-52)
cant seem to find any. Does anyone have the spec's for that part? Or can I sub the gear with a 56 year one (35809-56) I can find plenty of those
Re: counter shaft gear spacer
Posted:
Tue Nov 30, 2021 11:54 pm
by JerrryR
I don't believe the 35809-52 & the 35809-58 are interchangeable. The ID of the 35809-58 spacer is quite a bit larger than the -52 spacer and the widths are different. I do have one I would loan if you need to have one made.
- 35809-52 & 58.jpg (180.83 KiB) Viewed 6210 times
Re: counter shaft gear spacer
Posted:
Wed Dec 01, 2021 4:08 pm
by blewandoski
thanx for loan offer Jerry. I do know a gear head who can make one but I think a few pictures using a micrometer would work just as well...and saves on the shipping cost
Re: counter shaft gear spacer
Posted:
Wed Dec 01, 2021 6:00 pm
by 55panman
Yes Jerry, ID, OD and thickness would be quite handy for this spacer as I believe I need one also. Thanks, Ron
Re: counter shaft gear spacer
Posted:
Wed Dec 01, 2021 11:55 pm
by JerrryR
Re: counter shaft gear spacer
Posted:
Fri Dec 03, 2021 11:05 am
by blewandoski
thanx again Jerry...that is just what I needed
Re: counter shaft gear spacer
Posted:
Thu Jan 13, 2022 3:49 pm
by blewandoski
last question what type of steel is the spacer made out of?
Re: counter shaft gear spacer
Posted:
Thu Jan 13, 2022 4:54 pm
by JerrryR
That question is above my pay grade. This might be the reason I need to send it to you unless someone else knows.
Re: counter shaft gear spacer
Posted:
Thu Jan 13, 2022 8:19 pm
by dlxl66elxl
I may have one available, PM me. Dave